Toro titan Z4800 Service Manual page 106

Mower Deck Installation
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
neutral position, engage parking brake, stop the
engine, remove the key, and wait for all moving parts
to stop before leaving the operation position.
3. Slide the mower deck under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Use the existing hardware to attach the rear deck
strut of the mower to the deck lift arm (Fig. 295).
A
B
Fig. 295
A. Deck lift arm
2007 - 2008 Titan Z Service Manual
A
B
B. Deck strut
MOWER DECK
6. Attach the hardware from the deck hanger and deck
lift arm on both sides of the deck (Fig. 296).
A
B
Fig. 296
A. Deck lift arm
7. Route the mower deck belt around the engine pulley
and check the routing of the mower deck belt on the
mower deck (Fig. 297):
Fig. 297
8. Make sure the mower deck is level side-to-side, and
front-to-back. Refer to "Leveling the Mower Deck"
and "Adjusting the Blade Slope" (next).
B. Deck hanger
109-6035
5-19
5