BMW S 1000RR Rider's Manual page 176

9
174
Make sure that the wheel
speed sensor 1 is not
damaged when rolling out the
rear wheel.
z
Roll rear wheel toward rear
out of swing arm while pulling
brake caliper carrier 1 toward
rear until rear-wheel rim can be
guided past it.
NOTICE
The chain sprocket and the
spacer sleeves on the left and
right are loosely inserted in the
wheel. Exercise care during the
removal, in order that the parts
are not damaged or are lost.
Install rear wheel
ATTENTION
Altering the tire size.
Influence on the control systems.
When converting the rear tire
size from 190 ⁄ 55 ZR 17 to
200 ⁄ 55 ZR 17 or vice versa,
the parameters of the control
systems must be encoded by
a BMW authorized workshop,
preferably by a BMW Motorrad
retailer.
ATTENTION
Tightening of screwed con-
nections with incorrect tight-
ening torque.
Damage or loosening of screwed
connections.
Always have the tightening
torques checked by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Roll rear wheel on support into
swing arm until brake-caliper
support can be installed.