BMW S 1000RR Rider's Manual page 102

Individualizing LAPTIMER
7
100
Activate standard display
( 109).
The odometer (
played.
Briefly press SET 2.
z
The LAPTIMER is opened and
RUN
shows 3 and
LAP
4 in the factory setting.
To change content of lines 3
and 4 in LAPTIMER, repeat-
edly press and hold SET 2 un-
til lines 3 and 4 are displayed
as desired.
The desired LAPTIMER display
structure is adopted and saved.
LAPTIMER display structure
(
Starting time recording
The LAPTIMER is opened.
ODO
) is dis-
Press button 1 to start record-
ing.
BEST-
For the headlight flasher signal
to be detected, the engine must
be running and the motorcycle
moving.
Time recording
ning.
121)
NOTICE
RUN
2 is run-
When driving over Start/Finish
line, press button 1 again to
start recording for next race
lap.
The data of the preceding race
lap will be saved.
RUN
2 restarts at
00:00:00
.
If the display mode is exited
during a recording, then the
recording continues to run.
However, the recording of a
new lap can only be started in
the other modes with an exter-
nal signal.
Infrared receiver
with infrared receiver
The LAPTIMER can be conve-
niently operated with an infrared
signal. On this, the following
should be noted:
OA