Addendum - SATA Configuration
Table 8-1: SATA Hot-Plug Cage Cabling Diagram
No.
1 – 2
3 – 6
7
SATA Drive Installation
1. Perform steps 1 through 3 of the pre-installation instructions.
2. Remove the left-side cover.
3. Remove the front bezel.
4. Remove all hot-plug hard drives from the cage:
This step assumes that there is a drive currently installed in the cage. If the cage is empty,
go directly to step 5.
8-2
Figure 8-1: SATA hot-plug cage cabling diagram
Component Code
Left – CN2
Right – CN1
SATA1 – SATA4
(bottom to top)
CN5
HP ProLiant ML110 Server Operations and Maintenance Guide
Description
SATA power cables
SATA data cables
SATA LED cable