System Configuration
7. Install the HDD cage back into the chassis:
a. Guide the HDD cage into the chassis opening, with the cable connectors of the drive
b. Use the six Torx screws you removed earlier (step 4-c) to secure the cage to the
c. Connect a power cable to its connector on the rear of the new HDD.
d. Connect the data cable to its connector on the rear of the new HDD.
8. Observe the post-installation procedures.
4-14
Figure 4-12: Installing a hard disk in the HDD cage
facing the rear of the chassis, then push the cage all the way into the chassis.
chassis.
If there is any previously installed drive that is still in the cage, reconnect the power
cable of that drive.
If there is any previously installed drive that is still in the cage, reconnect the data
cable of that drive.
Figure 4-13: Installing the HDD cage
HP ProLiant ML110 Server Operations and Maintenance Guide