HP proliant ML110 Operation And Maintenance Manual page 78

System Maintenance
To resolve the problem:
1. Review the items under the "Troubleshooting Checklist" section earlier in this chapter.
2. Check that the keyboard:
•
•
•
3. If you are using a keyboard/monitor switch box, plug the keyboard directly into the
keyboard port of the server.
4. If the problem still persists, turn off the server then turn it back on.
5. Try replacing the keyboard with a known good keyboard.
Try using a USB keyboard.
6. Verify that you are using the latest BIOS for your HP ProLiant ML110 server.
Mouse Problems
The HP server automatically detects a mouse when one is installed. If it is not detected or if
any of the following conditions are present, there is a mouse problem:
•
The mouse does not work.
•
Inconsistency in the cursor's movement
To resolve the problem:
1. Review the items under the "Troubleshooting Checklist" section earlier in this chapter.
2. Check that the mouse cable is properly connected to the server.
3. If you are using a keyboard/monitor switch box, plug the mouse directly into the
keyboard port of the server.
4. Use the BIOS Setup Utility to make sure the mouse port's configuration does not have a
resource conflict.
5. Make sure that the correct mouse driver has been installed.
Refer to the documentation accompanying it for more information.
6. Replace the mouse with a known good unit.
Try using a USB mouse.
System Configuration Problems
An installed driver cannot find a PCI board.
Installing a PCI board that bridges two system PCI buses (certain adapter boards provide this
feature) can cause previously installed PCI drivers to not recognize the respective adapter
board(s). To resolve this, move the PCI board that has bridging capability to a PCI slot earlier
in the boot order.
6-12
Is not locked
Is clean and that no keys are stuck
Cable connections at the rear panel of the server and at the back of the keyboard are
securely and correctly attached
HP ProLiant ML110 Server Operations and Maintenance Guide