HP proliant ML110 Operation And Maintenance Manual page 45

System Configuration
DIMM Population Guidelines
DIMM population guidelines are illustrated in the figures below.
NOTE: While the four DIMM slots can accept different size DIMMs in any configuration, HP
recommends installing the smallest capacity module in slot 4 and progressively larger capacity modules
in slots 3, 2 and 1.
To Remove a DIMM
1. Perform steps 1 through 3 of the pre-installation instructions.
2. Remove the left-side cover.
3. Lay the server on its side (components showing) for better access to the DIMM slots.
4. If necessary, remove any accessory boards or SCSI cables that prevent access to the
DIMM slots.
5. Locate the DIMM you want to remove.
6. Remove the selected DIMM:
a. Completely open the holding clips securing the DIMM.
b. Gently pull the DIMM upward to remove it from its slot.
4-20
Figure 4-18: Single-channel mode operation
Figure 4-19: Dual-channel mode operation
This forces the DIMM up in the slot and makes it easier to remove.
HP ProLiant ML110 Server Operations and Maintenance Guide