HP proliant ML110 Operation And Maintenance Manual page 40

Mainboard Components
Processor
The mainboard's CPU socket supports a single 478-pin Intel processor.
To Remove a Processor
1. Perform steps 1 through 3 of the pre-installation instructions.
2. Remove the left-side cover.
3. Lay the server on its side (components showing) for better access to the CPU socket.
4. If necessary, remove any accessory boards or cables that prevent access to the CPU
socket.
5. Remove the heat sink-cooling fan assembly:
a. Disconnect the CPU fan cable from the connector on the mainboard.
b. Depress then unhook the two heat sink retention levers.
c. Remove the heat sink-cooling fan assembly by lifting it away from the mainboard.
6. Remove the processor from its socket:
a. Depress then lift up the socket retention bar up to a 90° angle.
b. Grasp the processor by its edges and lift it out of its socket.
HP ProLiant ML110 Server Operations and Maintenance Guide
Lay down the heat sink-cooling fan assembly down in an upright position—with the
thermal patch facing upward. Do not let the thermal patch touch the work surface.
Figure 4-14: Removing the heat sink-cooling fan assembly
System Configuration
4-15