HP proliant ML110 Operation And Maintenance Manual page 55

System Configuration
5.
OBDR Function
a. Press 1 to select the OBDR option.
b. Type the NUM value corresponding to the SCSI tape you want to place into OBDR
Multi-initiator Configuration
a. Press 2 to select the Multi-initiator Configuration option.
b. Enter the number for the card you want to configure.
c. Enter the new card ID.
d. Press x to save the configuration settings and close the utility.
4-30
Select a configuration option by pressing the corresponding item number.
•
Tape-based One Button Disaster Recovery (OBDR)
Select this option to perform recovery procedures for a SCSI drive that supports
OBDR function.
•
Multi-initiator Configuration
Select this option to perform initial setup SCSI configuration.
•
Exit
Select this option to close the utility. System will automatically reboot.
The utility will scan your server for any installed SCSI tapes and display the results.
A message prompt will be shown below the scan results.
<<<Please choose the NUM of the tape drive
mode.
Auto-configuration will be initialized after which the system will automatically
reboot.
The utility will scan your server for any installed SCSI cards and display the results.
A message prompt will be shown below the scan results.
Enter choice (y/Exit x)
y
where is the card number.
You will be prompted to change the card ID.
You will be prompted to confirm the status of the Reset SCSI BUS at IC
Initialization parameter.
By default, this parameter is enabled. Press Y to disable the parameter.
The system will automatically reboot.
to place into OBDR mode>>>
HP ProLiant ML110 Server Operations and Maintenance Guide