HP proliant ML110 Operation And Maintenance Manual page 17

Table 2-4: Mainboard Components
Item
27
28
29
Note: Listed in the next section are the default settings for the dip switch.
Dip Switch Settings
The table below shows the settings for the dip switch (SW1). The switch status indicated in
bold text is the default setting.
Table 2-5: DIP Switch Settings
Switch
SW1-1
SW1-2
SW1-3
SW1-4
SW1-5
SW1-6
SW1-5
SW1-6
SW1-5
SW1-6
Note: Set SW1-5 and SW1-6 to the combinations shown above to select the
operation mode for the PCI2 through PCI4 slots. Both switches, by default,
are set to the Off position, and are dependent on the card installed into each
slot.
HP ProLiant ML110 Server Operations and Maintenance Guide
Component Code Description
U14 SMSC LPC47M192 Super I/O chipset
CPU CPU socket
SYSFAN1 3-pin system fan connector (rear)
Switch Status
On
Off
On
Off
On
Off
On
Off
On
On
Off
On
On
Off
continued
Function
Clear CMOS Enabled
Clear CMOS Disabled
Boot Block Enabled
Normal Boot
Clear Password
Enabled
Clear Password
Disabled
No FWH Protection
FWH Protection by
Software Enabled
PCI 32 / 33MHz
PCI 64 / 66MHz
PCI-X 64 / 66MHz
System Structure
2-7