HP proliant ML110 Operation And Maintenance Manual page 29

System Configuration
3. Reinstall the left-side cover:
a. Use two hands to place the left-side cover's lower edge at an angle to the hinge tabs
b. With the cover resting on the hinge tabs, tilt the cover up until it engages the locking
c. Slide the cover towards the front panel to position it into place.
d. Once the cover is attached to the chassis, secure it by tightening the two captive
4. Perform steps 5 through 6 of the post-installation instructions.
Front Bezel
The front bezel must be removed to access the mass storage devices and the HDD cage.
To Remove the Front Bezel
1. Remove the left-side cover.
2. Remove the front bezel:
a. Press the two plastic retention clips on the bottom of the bezel upward to release
b. Tilt the bottom edge of the bezel away from the front panel to disengage it from the
4-4
along the bottom of the chassis.
The hinge tabs are keyed to accept the cover in only one position.
mechanism at the top of the chassis.
thumbscrews.
Figure 4-2: Reinstalling the left-side cover
them from their tabs on the inside of the front chassis.
chassis.
HP ProLiant ML110 Server Operations and Maintenance Guide