HP proliant ML110 Operation And Maintenance Manual page 81

3. Use the BIOS Setup Utility to make sure that the CD-ROM drive is bootable.
a. Reboot the server, then during POST press F2.
b. Select Boot from the Setup Utility's menu bar.
c. If necessary, move the CD-ROM option up the boot list.
d. Press F10 to save the configuration and close the Setup Utility.
SCSI Problems
The SCSI boot controller BIOS has trouble loading the Boot Logical Drive (NOS drive).
1. Make sure that the SCSI boot controller is bannering (displaying) during POST.
2. Use the BIOS Setup Utility to determine what the boot order is for this server. Verify that
the SCSI boot controller board is in the correct position in the boot order.
The boot order can be viewed and changed from this utility. If necessary, change the slot
(if applicable) that the SCSI controller is in to change the location in the boot order.
If the problem persists, proceed to the next step.
3. Clear CMOS and update the system BIOS.
Refer to Chapter 5 for related instructions.
4. Repeat step 2.
5. If you installed more than one SCSI controller, try disabling the BIOS on all other SCSI
controller except for the SCSI boot controller.
This lets the SCSI BIOS for the boot controller load and prevents conflicts with the other
SCSI controllers. If necessary, remove all the other SCSI controller boards except the
SCSI boot controller until the issue is resolved.
The SCSI device stops working.
•
Verify that the device banners during POST or is visible under the BIOS Setup Utility.
•
Run Diagnostics for Windows and verify the following items:
— SCSI IDs and any relevant switch settings
— SCSI bus information
•
If an accessory board was added recently:
1. Check for a resource conflict between the new board and an existing accessory
2. Remove the board and restart the server.
HP ProLiant ML110 Server Operations and Maintenance Guide
This ensures the CD-ROM will boot before any of the hard disk drives (IDE or
SCSI).
boards.
Ιf this corrects the problem, the new board is either defective or it is trying to use a
system resource used by another SCSI controller board.
System Maintenance
6-15