Parking Brake; Differential Lock - Toro Workman HD 07369 Operator's Manual

Gear-Shift Lever
Fully press the clutch pedal and move the shift lever
6) into the desired gear selection. A diagram of the shift
pattern is shown inFigure
Important: Do not shift the transaxle to the reverse or
forward gear unless the vehicle is standing still. Damage
to the transaxle may occur.
CAUTION
Down shifting from too high a speed can cause the
rear wheels to skid, resulting in loss of machine
control as well as clutch and/or transmission
damage.
Use care when shifting; do not down shift when the
machine is moving at too high a speed.

Differential Lock

The differential lock allows the rear axle to lock for increased
traction. You can engage the differential lock when the
machine is in motion (Figure
to the right to engage the lock.
Note: Machine motion plus a slight turn is required to
engage or disengage the differential lock.
CAUTION
Turning with the differential lock on can result in
loss of machine control.
Do not operate the machine with the differential
lock on when making sharp turns or at high speeds;
refer to Using the Differential Lock (page
5.
Figure 5
6) Move the lever forward and
28).
(Figure
1. Gear-shift lever

2. Parking brake

3. Hydraulic-bed lift
Parking Brake
Whenever the engine is shut off, the parking brake
in order to prevent the machine from accidentally moving.
•
To set the parking brake, pull back on the lever.
•
To release, push the lever forward.
Note: Release the parking brake before moving the
machine.
If you park the machine on a steep grade, set the parking
brake, shift the transmission into first gear on a uphill grade
or reverse gear on a downhill grade, and place chocks at the
downhill side of the wheels.
Hydraulic Lift
The hydraulic lift raises and lowers the bed. Move it rearward
to raise the bed, and forward to lower it
also locks the lift lever in the O
hydraulics for attachments.
Important: When lowering the bed, hold the lever in
the forward position for 1 or 2 seconds after the bed
contacts the frame to secure it in the lowered position.
Do not hold the hydraulic lift in either the raise or lower
position, for more than 5 seconds, once the cylinders
have reached the end of their travel.
Hydraulic-Lift Lock
The hydraulic-lift lock locks the lift lever, so the hydraulic
cylinders do not operate when the machine is not equipped
with a bed (Figure
position when using the hydraulics for attachments.
16
Figure 6
4. Hydraulic-lift lock
5. Differential lock
6. High–low range shifter
(Figure
position when using the
N
6). It also locks the lift lever in the O
(Figure 6)
6). It
N