Lubrication; Greasing Bearings And Bushings - Toro Workman HD 07369 Operator's Manual

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 100 hours (Lubricate more frequently
in heavy duty applications)
The machine has grease fittings that must be lubricated
regularly with No. 2 lithium grease.
The grease-fitting locations and quantities are as follows:
•
Ball joints (4), tie rods (2), pivot mounts (2) and steering
cylinder (2) as shown in
•
Spring tower (2) as shown in
•
Clutch (1), accelerator (1), brake (1) as shown in
•
U-joint (18) as shown in
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
Figure 35
Figure 35
Figure 36
Figure 37
Figure 38
38
Figure 36
Figure 37
Figure 38