Adding Fuel - Toro Workman HD 07369 Operator's Manual

oil level to the Full mark. Do not overfill the engine with
oil. If the oil level is between the Full and Add marks, no
additional oil is required.
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean rag
(Figure 13).
1. Filler cap
3. Insert the dipstick into the tube and make sure that
it is seated fully.
4. Remove dipstick and check the level of the oil.
5. If the oil level is low, remove the filler cap
and add enough oil to raise the level to the Full mark
on the dipstick.
Note: When adding oil, remove dipstick to allow
proper venting. Pour the oil slowly and check the level
often during this process. Do not overfill the engine
with oil.
Important: When adding engine oil or filling
oil, there must be clearance between the oil fill
device and the oil fill hole in the valve cover as
shown in Figure 14. This clearance is necessary
to permit venting when filling, which prevents oil
from overrunning into the breather.
Figure 13
2. Dipstick
(Figure
1. Note clearance
6. Install the dipstick firmly in place.

Adding Fuel

Fuel-tank capacity: 25 L (6.5 US gallons).
•
For best results, use only clean, fresh (less than 30 days
old), unleaded gasoline with an octane rating of 87 or
higher ((R+M)/2 rating method).
•
Ethanol: Gasoline with up to 10% ethanol (gasohol)
or 15% MTBE (methyl tertiary butyl ether) by volume
is acceptable. Ethanol and MTBE are not the same.
13),
Gasoline with 15% ethanol (E15) by volume is not
approved for use. Never use gasoline that contains
more than 10% ethanol by volume, such as E15
(contains 15% ethanol), E20 (contains 20% ethanol), or
E85 (contains up to 85% ethanol). Using unapproved
gasoline may cause performance problems and/or engine
damage which may not be covered under warranty.
•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or fuel containers
over the winter unless a fuel stabilizer is used.
•
Do not add oil to gasoline.
21
Figure 14