Storage - Toro Workman HD 07369 Operator's Manual

Storage

1. Position the machine on a level surface, set the parking
brake, shut off the engine, and remove the ignition key.
2. Clean dirt and grime from the entire machine, including
the outside of the engine-cylinder-head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not use high-pressure
water to wash the machine. Pressure washing
may damage the electrical system or wash away
necessary grease at friction points. Avoid excessive
use of water, especially near the control panel,
lights, engine, and the battery.
3. Inspect the brakes; refer to
Level (page 24).
4. Service the air cleaner; refer to
Cleaner (page 39).
5. Grease the machine; refer to
Bushings (page 38).
6. Change the engine oil and filter; refer to
Engine Oil and Filter (page
7. Check the tire pressure; refer to
Pressure (page 23).
8. For storage over 30 days, prepare the fuel system as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank.
Follow mixing instructions from stabilizer
manufacturer. Do not use an alcohol based
stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and used
at all times.
B. Run the engine for 5 minutes to distribute
conditioned fuel through the fuel system.
C. Shut off the engine, allow it to cool, and drain
the fuel tank.
D. Start the engine and run it until it stops.
E. Choke the engine.
F. Start and run the engine until it does not start
again.
G. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned gasoline over 90
days
9. Remove the spark plugs and check their condition;
refer to Replacing the Spark Plugs (page
Checking the Brake-Fluid
Servicing the Air
Greasing Bearings and
Changing the
40).
Checking the Tire
40).
10. With the spark plugs removed from the engine, pour 2
tablespoons of engine oil into the spark-plug hole.
11. Use the starter to crank the engine and distribute the
oil inside the cylinder.
12. Install the spark plugs and tighten to recommended
torque; refer to
Note: Do not install the wire on the spark plug(s).
13. Remove the battery from the chassis and charge it fully;
refer to Servicing the Battery (page
Note: Do not connect the battery cables to the battery
posts during storage.
Important: The battery must be fully charged to
prevent it from freezing and being damaged at
temperatures below 32°F (0°C). A fully charged
battery maintains its charge for about 50 days
at temperatures lower than 40°F (4°C). If the
temperatures will be above 40°F (4°C), check the
water level in the battery and charge it every 30
days.
14. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
15. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service
Distributor.
16. Store the machine in a clean, dry garage or storage area.
17. Remove the ignition key and put it in a safe place out
of the reach of children.
18. Cover the machine to protect it and keep it clean.
53
Replacing the Spark Plugs (page
43).
40).