Cleaning; Washing The Machine - Toro Workman HD 07369 Operator's Manual

5. On the other machine, connect the 2 hoses to the
coupler still in the coupler bracket (connect the top
hose to the top coupler and the bottom hose to the
bottom coupler) (Figure
6. Cap the unused fittings.
Figure 70
1. Jumper hoses
7. Keep all bystanders away from the machines.
8. Start the second machine, and move the lift lever to the
raise position which will raise the disabled cargo box.
9. Move the hydraulic-lift lever to the N
and engage the lift-lever lock.
10. Install the bed support onto the extended lift cylinder;
refer to Using the Bed Support (page
Note: With both the machine turned off, move the lift
lever back and forth to remove the system pressure and
ease the disconnection of the quick couplers.
11. After completing the operation, remove the jumper
hoses and connect the hydraulic hoses to both
machines.
Important: Check the hydraulic fluid levels, in
both vehicles, before resuming operation.
70).
position,
EUTRAL
34).

Cleaning

Washing the Machine

Wash the machine as needed. Use water alone or with a mild
detergent. You may use a rag when washing the machine;
however, the hood will loose some of its luster.
Important: Do not use power-washing equipment to
wash the machine. Power-washing equipment may
damage the electrical system, loosen important decals,
or wash away necessary grease at friction points. Avoid
excessive use of water near the control panel, engine,
and battery.
Important: Do not wash the machine with the engine
running. Washing the machine with the engine running
may result in internal engine damage.
52