Product Overview; Controls - Toro Workman HD 07369 Operator's Manual

Figure 3
1. ROPS mounting bracket
3. Secure each side of the ROPS mounting bracket to
frame of the machine with 3 flange-head bolt (1/2 x
1-1/4 inch).
4. Torque the flange-head bolts to 115 N·m (85 ft-lb).
2. Flange-head bolt (1/2 x
1-1/4 inches)

Product Overview

Controls

Note: Determine the left and right sides of the machine
from the normal operating position.
Accelerator Pedal
The accelerator pedal (Figure
to vary the engine and ground speed of the machine when
the transmission is in gear. Pressing the pedal increases the
engine speed and ground speed. Releasing the pedal decreases
the engine speed and ground speed of the machine.
1. Accelerator pedal
2. Clutch pedal
Clutch Pedal
You must fully press the clutch pedal
the clutch when starting the engine or shifting transmission
gears. Release the pedal smoothly when the transmission is
in gear to prevent unnecessary wear on the transmission and
other related parts.
Important: Do not ride the clutch pedal during
operation. The clutch pedal must be fully out or the
clutch will slip, causing heat and wear. Never hold
the machine stopped on a hill using the clutch pedal.
Damage to the clutch may occur.
Brake Pedal
Use the brake pedal (Figure
to stop or slow the machine.
CAUTION
Worn or maladjusted brakes may result in personal
injury.
If the brake pedal travels to within 3.8 cm (1-1/2
inches) of the machine floor board, adjust or repair
the brakes.
15
4) gives the operator the ability
Figure 4
3. Brake pedal
(Figure 4) to disengage
4) to apply the service brakes