Renaming an input source
You may rename the current input source on the source selection bar.
To do this, first and foremost, you have to access the Advanced OSD menu (see
for details).
1.
Press
2.
Press
window.
3.
Press
and press
•
To delete a character, move to the Del key and press
•
To delete all characters, move to the Reset key and press
4.
When done, press
Adjusting the projected image
Adjusting the image height
The projector is equipped with 2 adjuster feet. These adjusters change the image height.
To adjust the projector:
•
Screw the adjuster feet to adjust the
image height.
•
To retract the feet, screw the adjuster
feet in reverse direction.
If the projector is not placed on a flat
surface or the screen and the projector are
not perpendicular to each other, the projected image becomes trapezoidal. To correct this
situation, see
"Correcting keystone" on page 35
•
Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes.
•
Be careful when you screw the adjuster foot as it is close to the exhaust vent where hot air
comes from.
and then use
/
to select Source Rename and press
/
/
/
to move the cursor until your desired character is selected
to confirm.
to save your changes and exit.
to go to the System Setup : Basic menu.
to display the Source Rename
for details.
page 37
.
.
Operation
33