Selecting An Input Source - BenQ CH100 User Manual

Selecting an input source

The projector can be connected to multiple equipment at the same time. However, it only
displays one full screen at a time. When starting up, the projector automatically searches for
the available signals.
If you want the projector to always automatically search for the signals:
• Under the Advanced OSD menu, go to the System Setup : Basic menu, and enable
Quick Auto Search (see
• Under the Basic OSD menu, if there's no signal connected to the projector, go to
Auto Source Search and enable it; if there are signals connected, go to the Settings
menu, and then enable Auto Source Search.
To select the video source:
1. Press
2. Press
Once detected, the selected source information displays on the screen for seconds. If
there are multiple pieces of equipment connected to the projector, repeat steps 1 to
2 to search for another signal.
The native display resolution of this projector is in a 16:9 aspect ratio. For best display picture
results, you should select and use an input signal which outputs at this resolution. Any other
resolutions will be scaled by the projector depending upon the Aspect Ratio setting, which may
cause some image distortion or loss of picture clarity. See
32 Operation
"Quick Auto Search" on page
to display the source selection bar.
/ until your desired signal is selected and press
Source
HDMI 1 / MHL
HDMI 2
HDMI 3
PC / Component
"Aspect
54).
.
Ratio" for details.