Table of Contents
Advertisement
projector's resolution or set the input signal to a lower setting. See
chart" on page 77
To maintain the lamp life, once you turn the projector on, wait at least 5
minutes before turning if off.
Using the quick install
The projector provides a hot key to set Projector
Installation, Test Pattern, and Keystone quickly.
Press Quick Install on the remote control and press ▲/▼
to select:
• Projector Installation: See
• Test Pattern: See
• Keystone: See
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 3 adjuster feet. These adjusters change the
image height and projection angle. To adjust the projector:
Screw adjuster foot to fine tune the
horizontal angle.
To retract the foot, hold up the projector
then slowly lower the projector. Screw the
adjuster foot in a reverse direction.
If the projector is not placed on a flat
surface or the screen and the projector are
not perpendicular to each other, the
projected image becomes trapezoidal. To
correct this situation, see
keystone" on page 30
• Do not look into the lens while the lamp is on. The strong light from the
lamp may cause damage to your eyes.
• Be careful when you press the adjuster button as it is close to the exhaust
vent where hot air comes from.
Operation
for details.
QUICK INSTALL
Projector
Test Pattern
Keystone
"Positioning your projector" on page
"Using the test pattern" on page
"Correcting keystone" on page
"Correcting
for details.
MENU Exit
48.
30.
"Timing
20.
29
Advertisement
Table of Contents
