Table of Contents
Advertisement
Troubleshooting
The projector does not turn on.
Cause
There is no power from the power cord.
Attempting to turn the projector on
again during the cooling process.
No picture.
Cause
The source is not turned on or the cable
is not connected correctly.
The projector is not correctly connected
to the input signal device.
The input signal has not been correctly
selected.
Blurred image.
Cause
The projection lens is not correctly
focused.
The projector and the screen are not
aligned properly.
Remote control does not work.
Cause
The battery is out of power.
There is an obstacle between the remote
control and the projector.
You are too far away from the projector.
The password is incorrect.
Cause
You do not remember the password.
Remedy
Plug the AC adapter into the DC IN socket on the
projector, plug the power cord into the AC inlet
on the AC adapter, plug the power cord into the
power outlet. If the power outlet has a switch,
make sure that it is switched on.
Wait until the cooling down process is complete.
Remedy
Turn the source on and check that the signal cable
is connected correctly.
Check the connection.
Select the correct input signal with the
key.
Remedy
Adjust the focus of the lens using the focus ring.
Adjust the projection angle and direction as well as
the height of the unit if necessary.
Remedy
Replace the battery with new one.
Remove the obstacle.
Stand within 8 meters (~26 feet) of the projector.
Remedy
Please see
"Entering the password recall
procedure" on page 30
/
for details.
Troubleshooting
63
Advertisement
Table of Contents
