Table of Contents
Advertisement
2.
Select Change Password and press
window.
3.
Use the arrow keys to enter the old password.
•
If the password is correct, the Input New Password window displays.
•
If the password is incorrect, the password error message displays, and the Input
Current Password window displays for your retry. You can either try another
password or press
4.
Enter a new password.
5.
Re-enter the same password to verify.
Do make a note of your password, and keep the note in a safe place for later recall.
6.
You have successfully set a new password. Remember to enter the new password
next time you turn on the projector.
7.
Press
to save your changes and exit.
Disabling the password function
To do this, first and foremost, you have to access the Advanced OSD menu (see
for details).
1.
Go to the System Setup : Advanced > Password menu to display the Password
window.
2.
Select Power On Lock and use
3.
Enter the current password.
•
If the password is correct, the Password window displays that Power On Lock
is Off. You will not be asked to enter the password next time when turning on the
projector.
•
If the password is incorrect, the password error message displays, and then the
Input Current Password window displays for your retry. You can either try
another password or press
4.
Press
to save your changes and exit.
Though the password function is disabled, you need to keep a note of the old password in case
you ever need to re-activate the password function by entering the old password.
to display the Input Current Password
Input Current Password
to cancel the change.
/
to set Off.
to cancel the change.
Back
Operation
page 37
31
Advertisement
Table of Contents
