Kyocera Mita FS-C5016N Operation Manual page 139

3.13 Other Modes
Sleep Timer Timeout Time
You can adjust the timer timeout time, the length of time the printer waits before entering
sleeping mode in the absence of data. The default sleep timer timeout time is 15 minutes.
The printer reverts to normal operation mode when the printer receives a print job, the
operator panel is operated, or one of the exterior covers is opened.
Color calibration is automatically executed before the printer reverts to
normal operation mode.
Note
To confirm and change the timeout time, proceed as follows:
1
Press the MENU key.
2
Press the or
Others
3
Press the key.
4
Press the or
>Sleep Timer
015min.
5
To change the timeout time, press the ENTER key. A blinking cursor (_) appears.
>Sleep Timer
015min.
6
Press the or
the desired time. The timer can be set between 5 and 240 min, in 5-minute
increments. Use the
7
When the desired timeout time is displayed, press the ENTER key.
8
To exit the menu selection, press the MENU key.
key repeatedly until Others > appears.
>
key repeatedly until >Sleep Timer > appears.
>
key to increase or decrease the value at the blinking cursor and set
and keys to move the cursor right and left.
3-92