Rear - Kyocera Mita FS-C5016N Operation Manual

1.2 Parts and Functions
1.2.4

Rear

1
3
Figure 1-4
1 Vents
Air is purged through these vents to cool down the inside.
2 USB Interface Connector
This connector is a USB interface that conforms to the Full-Speed USB 2.0. Use a USB
cable between this connector and the USB port on a computer.
3 Memory Card Slot
This slot receives a memory card. A memory card can hold fonts, macros, forms, etc.,
that can be downloaded in the printer's memory. For details, see
section A.3.1 Memory Card on page
4 Power Cord Connector
This connector accepts the power cord supplied with the printer.
5 Network indicators
These indicators light according to the communication status with the network.
Right: 10BASE-T/100BASE-TX indicator
Lights when you are connected to the network at 10 Mbps or 100 Mbps.
Left: Status indicator
Flashes during data communication.
6 Network Interface Connector
Connects to the network via a 10BASE-T/100BASE-TX network cable.
7 Parallel Interface Connector
This connector is for a standard Centronics parallel interface cable from the computer.
Connect this connector to the computer's parallel port.
8 Option Interface Slot (Network/Serial)
This slot can be used to hold the optional network interface card, a hard disk or the
serial interface board kit. For details, see
1 1
4
A-7.
Appendix A
1-8
5 8
7 2
Appendix A Options,
Options.
6