Kyocera Mita FS-C5016N Operation Manual page 114

• The RAM disk can not be used when an optional hard disk is installed.
• The RAM disk stores data only temporarily. When the printer is reset or
Note turned off, the stored data will be erased.
• The RAM disk is allocated within the printer's memory available to
users. If the size of the RAM disk is set too large, the printing speed may
decrease or the memory may become insufficient.
To confirm the RAM disk size or activate the RAM disk, proceed as follows:
Setting the RAM Disk Size
1
Press the MENU key.
2
Press the or
RAM Disk Mode
Off
3
Press the ENTER key. A blinking question mark (?) appears. Press the
to select On. Press the ENTER key.
RAM Disk Mode
? On
4
Press the key. Press the
appears. The data size also appears.
>RAM Disk Size
0119 MByte
5
Press the ENTER key. A blinking cursor (_) appears. Press the
display the desired size. Definable RAM disk size is 0001 to 1024.
>RAM Disk Size
0119 MByte
This range varies depending on the total memory size of the printer. The setting
exceeding this range is automatically adjusted to the maximum RAM disk size.
6
When the desired RAM disk size is displayed, press the ENTER key.
7
Press the MENU key. The display returns to Ready. Then, turn off the printer and on
again. The selected RAM disk size is activated after the printer is restarted.
key repeatedly until RAM Disk Mode appears.
or key repeatedly until >RAM Disk Size
3-67
3.9 Operating the Storage Device
or
or key to
key