Kyocera Mita FS-C5016N Operation Manual page 156

Printed Results
Grey background
Dirt on the top edge or back of the paper
Table 4-2 (Continued)
Corrective Action
Clean the main charger units.
Open the left cover. Slowly pull the green wire
cleaner knob to each of the main charger units in
and out a few times. For full details, see
Maintenance, section 5.3.1 Cleaning the Main
Charger Unit on page
Check the charger units installation.
Open the left cover and check that the charger units
are correctly installed and seated as far as it will go.
See Chapter 5 Maintenance, section 5.3 Cleaning
the Printer on page
Conduct color calibration either by switching the
printer off then on or using the printer operator
panel. For full details, see
Operator Panel, section 3.13.13 Color Calibration
on page
Check the paper chute and the ramp.
Pull out the paper transfer unit and check for toner
on the paper ramp. Clean the paper ramp using a
soft, dry, lint-free cloth. For details, see
Maintenance, section 5.3.2 Cleaning the Paper
Transfer Unit on page
Paper Ramp
Clean the main charger units.
Open the left cover. Slowly pull the green wire
cleaner knob to each of the main charger units in
and out a few times. For full details, see
Maintenance, section 5.3.1 Cleaning the Main
Charger Unit on page
Clean the parts in the paper paths—such as the
paper cassette, etc.
Check the transfer roller.
If the transfer roller is dirty with toner, try printing
several pages.
4-5
4.2 Print Quality Problems
5-11.
5-11.
Chapter 3 Using the
3-104.
5-16.
5-11.
Chapter 5
Chapter 5
Chapter 5