Regulator/Ignition Unit; Checking The Ignition System - PEUGEOT Kisbee Workshop Manual

ELECTRICITY

Regulator/Ignition unit

- Remove the rear cover assembly. See:
Procedure 2. page 20.
- Removal:
• Regulator (1).
• The ignition module (2).

Checking the ignition system

Disconnect the ignition unit and perform the
measurements
side (3 Connectors).
If the values are correct, replace the ignition
module.
If the values are incorrect, check:
- The harness.
- The ignition switch.
- The high voltage coil.
- The magneto.
- The transmission sensor.
Component
Ground
Ignition switch:
Ignition on
Ignition off
Engine cut-off
Drive sensor
Ignition sensor
Low voltage coil
HT coil:
Primary
Secondary
Spark plug socket
54
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
on the harness
Connector
A
A
A
B White/black_Green
C
A Yellow/blue_Green
B
A Yellow/black_Green
High voltage wire_Green
2
B
A
Wire colours
Green_Ground
Black_Green
Black_Green
Blue_Green
Red/black_Green
1
C
Standard values
R = 0
V = 12 Volt (Battery voltage)
V = 0 Volt
Ignition on:
Ignition off:
±20%
R = 145
±20%
R = 145
R = 517
±20%
R = 0.5
±20%
R = 3.7 K
R = 5 K