DRAINING THE RELAY BOX
FR
We advise you to go to a registered
dealer for draining.
Oil contains substances which are
GB
harmful to the environment. Your dealer is
equipped to dispose of used oil without
endangering the environment and in
compliance with current standards.
DE
The gearbox must be drained when the engine is warm so
that the oil will run easier.
IT
ES
NL
5
GR
• Place the vehicle on its central stand on flat ground.
• Place a container under the drain port.
• Remove the relay box filler cap (4).
• Remove the drain plug (5).
SE
• Re-install the plug with a new seal.
• Pour the required quantity of oil corresponding to the
manufacturer's standards into the filler hole.
• Fit the filler cap.
PT
Relay box
FI
Quantity
DK
18/23
• Insert the drain plug fitted with a new seal.
• Pour the required quantity of oil corresponding to the
manufacturer's standards into the filler hole.
• Fit the cap/oil gauge.
• Start the engine and let it run for a short while.
• Check and adjust the oil level if necessary.
• Check that the oil drain plug is sealed.
4
SAE 80W90 API GL4
0.17 l at oïl change
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
REPLACING THE AIR FILTER
You are advised to contact a registered
dealer to have this operation carried out.
SETTING THE IDLE SPEED
The engine must be at its operating temperature.
• Switch off the engine.
• Place the vehicle on its central stand on flat ground.
• Open the storage compartment.
• Remove the access door.
• Check the operating clearance in the throttle.
• Start the engine.
• Screw or unscrew the engine speed adjuster screw (1)
to alter the idle speed.
• The rear wheel should not turn.
Idle speed
125/151 cc
1700 to 1900 rpm
1