Table of Contents
Advertisement
12 Changing the Camera's User Name
12 Changing the Camera's User Name
To view images from cameras registered using Quick Setup on a computer without
setting the user name or password, change the user name and password for a
camera using the following procedure.
1.
Select [General Setup] from the [Setup] screen (see page 79) and press
ENTER.
2.
Set the user name and password on the [Camera] tab (see page 84).
3.
Move the mode switch on the BL-WV10 to Setup and turn the power on again.
4.
Reset the camera to its default settings and re-perform Quick Setup as when
adding more cameras (see page 126).
•
To see a camera image on a computer, launch a web browser on the
computer and access the camera.
•
The administrator user name and password for the camera are the same
as the user name and password set in step 2 above.
Note
•
When Quick Setup begins, the Quick Setup screen for the camera in question
will change from [Complete] to [Setting]. When registration is complete,
[Finished] will be displayed.
•
The user name and password must be between 6 and 15 alphanumeric
characters in length. The following characters cannot be used:
" ' & < > :
128
Advertisement
Table of Contents
