Table of Contents
Advertisement
2 Setup
Note
•
If a user name and password has already been established for a camera, Quick
Setup will be unable to replace that data with the user name and password for
the BL-WV10, and the camera will be registered as a remote camera. To
register the camera as a local camera, reset the camera by pressing its
FACTORY DEFAULT RESET button before connecting it.
•
Quick Setup can take place within 20 minutes after the camera is turned on. If
the camera is not recognized, or if [Restarting camera] is displayed at the
bottom of the screen for more than 2 minutes without camera registration
beginning, reset the camera by pressing its FACTORY DEFAULT RESET
button and reconnect the camera.
•
If a camera needs to be restarted during Quick Setup, camera configuration
and restart will take about 2 minutes.
•
During Quick Setup, the wireless indicator will light in green.
•
Once registration is complete, the alarm will sound and the wireless indicator
will flash green.
2.5.4
Viewing Camera Images (When Not Using a Router)
After you have registered cameras to the BL-WV10 using Quick Setup, confirm that
images from the camera can be viewed using the BL-WV10.
1.
Connect all cameras that were registered using Quick Setup.
•
To use a wireless camera with the BL-WV10, turn the camera off,
disconnect the Ethernet cable, set the camera's wired/wireless switch (if it
has one) to WIRELESS, then turn the camera on again.
2.
Turn on the BL-WV10 by connecting the DC cord to the unit.
•
The startup screen appears on the TV screen.
3.
Confirm that the camera image is displayed.
•
If multiple cameras are registered, press 0 to display the camera list, then
use the up and down navigator keys to view images from each registered
camera.
Note
•
If the BL-WV10 does not receive date and time information from any of the
connected cameras, the [Date and Time] screen will appear. Select the current
date and time using the navigator keys on the remote control, and press
ENTER when finished.
•
If a camera image does not appear, check the connection and then restart the
camera. If the image still fails to appear, reset the camera to its default values,
and re-register it using Quick Setup.
•
The date and time is displayed in the upper-right corner of the screen. If the
date and time setting is not correct, set the correct date and time (see page 80).
32
Advertisement
Table of Contents
