Table of Contents
Advertisement
•
To configure a wireless camera with a wired/wireless switch, such as the
BL-C30, set the switch to WIRED during Quick Setup.
3.
Connect the camera to the power outlet.
Rear panel of
BL-WV10
4.
Wait while the Quick Setup utility restarts, configures, and registers the
camera.
•
When the camera has been configured and registered, [Finished] is
displayed next to the camera name ([CAM1], for example) and the alarm
sounds.
•
If [This camera's firmware is out of date] is displayed, you must update the
camera's firmware. Refer to the information on page 3. It is also
recommended that you erase the camera (see page 104) and then
register it again.
LAN jacks
Ethernet cable
Router
Rear panel
of camera
To
power
outlet
Bottom of BL-C30
2 Setup
25
Advertisement
Table of Contents
