Change Sensor Mode From Remote Access; Remote Access Code - VTech VS150 TWIN User Manual

CHaNge SeNSOR mODe fROm RemOTe aCCeSS

1. Follow steps 1 and 2 in Remote access section on page 82 to
enter remote access mode.
Press * on your remote touch-tone telephone to enter the sensor
2.
mode command session.
3. You can enter one of the following remote commands to change
to the respective sensor mode.
Command
1
2
3
NOTES
• The sensor mode command session in remote access is only for changing
the sensor mode settings.

RemOTe aCCeSS CODe

A two-digit security code is required to
access the answering system remotely from
any touch-tone telephone. The preset code
is 19. You can set the code from 00 to 99.
Press MENU when the phone is not in use.
1.
2. Press or
or PHONEBOOK / on the telephone base
to scroll to Answering sys, and then
press SELECT.
3. Press or
CALLS /
the telephone base to scroll to Ans sys setup then press SELECT.
4. Press or
on the telephone base to scroll to Remote code, and then press
SELECT.
5. Use the dialing keys to enter a two-digit number.
6. Press SAVE
Change to Local mode.
Change to Remote mode.
Turn off all alerts in local mode.
on the handset, or CALLS /
on the handset, or
or PHONEBOOK / on
on the handset, or CALLS / or PHONEBOOK /
to save and you hear a conirmation tone.
Description
84