VTech VS150 TWIN User Manual page 45

NOTES
•
For the last 10 seconds of exit delay time, there will be a beep every
second.
•
When a delay time has been set, there will not be any local or remote call
alerts when a monitored garage door or contact sensor is open, or when
there is motion in the monitored area, during the delay time.
•
If you are not able to exit home before the delay time ends, you can reset
and start the delay time again when you are ready to leave:
- switch the sensor mode to Local, and then switch it back to Remote; or
- press DISARM to switch the sensor alert system to Disarmed,
and then press ARM to switch it back to Armed.
•
The delay time set will be activated when:
- the sensor mode is switched to Remote from the Armed-Local
mode; or
- the sensor alert system is switched to Armed from the Disarmed-
Remote mode.
MODE
1. Press
2. Press or
the telephone base to scroll to choose Remote, and then press
OPTIONS.
3. Press or
the telephone base to scroll to choose Set delay and then press
SELECT.
4. Press or
on the telephone base to scroll to choose On, and then press
SELECT
to proceed to choose the exit delay time.
To skip time delay setting, scroll to choose Off, and then
•
press SELECT.
5. Press or
on the telephone base to scroll to choose 3 minutes, 5 minutes
or 8 minutes, and then press
entrance delay time.
6. Press or
the telephone base to scroll to choose 0 minutes, 1 minute or 3
minutes, and then press
on the handset or telephone base when idle.
on the handset, or CALLS /
on the handset, or CALLS /
on the handset, or CALLS /
on the handset, or CALLS /
on the handset, or CALLS /
SELECT
SELECT
to proceed to choose the
to save the delay time.
35
or PHONEBOOK/ on
or PHONEBOOK/ on
or PHONEBOOK/
or PHONEBOOK/
or PHONEBOOK/ on