VTech VS150 TWIN User Manual page 36

Mount spacer with tape
1. Attach mounting tape A onto
the rectangular area at the
rear side of the spacer.
2. Stick the spacer onto the
frame.
-OR-
Mount spacer with screws
1. Use a pencil to mark two
holes on the desired
location on the frame, with
the aid of the two holes on
the spacer of the sensor
unit. Then, remove the
spacer and drill two holes
into the frame.
2. Align the holes on the spacer
with the holes on the frame.
Tighten the large screws
into the holes to secure the
spacer onto the frame.
Mount sensor unit onto spacer
3. Press the latch button on
the sensor unit to open the
battery compartment case
from the back cover.
4. Align the holes on the
battery compartment back
cover with the holes on the
mounted spacer.
5. Tighten the small screws
into the holes to secure the
back cover of the sensor
onto the mounted spacer.
6. Push the battery
compartment case back
onto the mounted spacer
until it securely clicks into
place.
With Spacer
26
A