VTech VS150 TWIN User Manual page 99

The display shows
To register HS, see
manual to register.
The handset does
not work at all.
The display shows
Low battery and
lashes.
The display shows
Sensor X Low
battery.
The sensor does not
work at all.
I cannot receive
alerts when the
monitored garage
door or contact
sensor is opened.
The answering
system does not
announce the
correct day of the
week for recorded
messages time
stamp.
The answering
system does not
answer after
correct number of
rings or does not
record messages.
The handset is deregistered from the telephone
base. Place the handset in the telephone base
to register it back. The handset shows
VTECH X Registered and you hear a beep
when the registration process completes. This
process takes about 60 seconds to complete.
Place the handset in the telephone base or
charger for charging.
Press and hold CANCEL on the handset or
telephone base to erase the message.
Replace the batteries with new ones.
Make sure batteries are installed.
The sensor may be out of range. Move the
sensor closer to the telephone base.
Make sure the sensor alert system is in armed
mode and that
If the icon does not appear on the display, press
ARM to turn on the sensor alert system.
For various alerts behavior, please check the
settings of alert notiications (page 40) and
individual sensors' alert schedule (page 37 to
39).
Make sure you have set the date and time. See
Conigure your telephone section.
Make sure the answering system is on. When
the answering system is on, the telephone base
and handset show ANS ON and the /ANS ON
light on the telephone base is on.
If toll saver is selected, the number of rings
changes to two when there are new messages.
89
L
R
or appears on the display.