Designating 500-Type Telephones; Analog 500-Type Telephone; Procedure - Nortel M3110 Installation Manual

Procedure 56

Designating 500-type telephones

1 Remove the finger wheel (refer to Procedure 57 on
2 Remove the number card from its envelope.
3 Designate the number card with the appropriate directory number and
station designator.
4 Insert the number card into the finger wheel (making sure the number
card is properly oriented).
5 Place the telephone on a flat surface.
6 Place the finger wheel over the clamp on the dial, with the "0" hole directly
over the digit "9," making sure the finger wheel depressions are properly
positioned on the prongs of the clamp plate.
7 Rotate the finger wheel counterclockwise until the clamp spring snaps into
the notch on the underside of the finger wheel.
Follow the steps in Procedure 57 to remove the finger wheel from 500-type
telephones.
Procedure 57
Removing the finger wheel from

analog 500-type telephone

1 Place the telephone on a flat surface.
2 Rotate the finger wheel clockwise as far as possible.
3 Insert a paper clip into the small hole between the digits "9" and "0"
located on the edge of the grooved section of the finger wheel.
4 Press down on the releaser to disengage the finger wheel clamp spring.
5 Rotate the finger wheel further clockwise until the clamp spring releases.
6 Remove the finger wheel when it becomes loose. The dial returns to
normal position.
Telephones and Consoles
Analog (500/2500-type) telephones
End of Procedure
End of Procedure
Description, Installation, and Operation
Page 311 of 504
page 311).