Wall-Mounting The Telephone; Procedure - Nortel M3110 Installation Manual

Wall-mounting the telephone

For the M3903, M3904, and M3905 Digital Telephones, a separate
wall-mount bracket kit must be used to wall-mount the telephone. The
telephone wall-mount bracket kit contains a one-piece wall-mount plate to
attach the telephone to the wall. For the M3901 and M3902 telephones, the
supplied footstand can be reversed to allow wall-mount installation. An
optional wall-mount brace kit may be purchased for the M3901 and M3902
to provide additional support.
Note: The Key-Based and Display-Based Accessory modules cannot be
wall-mounted.
Use Procedure 31 to wall-mount the telephone.

Procedure 31

Wall-mounting the telephone
1 Place the wall-mount bracket against the wall and mark the spot to insert
the screws.
Note: M3901 and M3902 have built-in wall-mount brackets.
2 Screw the five screws in and leave about 3 1/2 mm (1/8 inch) between the
head of the screw and the wall.
3 Remove the footstand from the telephone by sliding the footstand down
(using the plastic hinges) about 7 mm (1/4 inch).
4 Swing the footstand away from the telephone base and remove from the
telephone.
5 Attach the wall-mount bracket onto the back of the telephone by placing
the telephone at the top edge of the wall-mount bracket and sliding the
telephone into place.
6 Mount the wall-mount bracket, attached to the telephone onto the screws
located on the wall.
Telephones and Consoles
M3900 installation and configuration
Description, Installation, and Operation
Page 191 of 504