Write Threshold; Flash Update; Figure 3-51. Sample Event Log Entry Exceeding The Write Threshold; Figure 3-52. Sample Event Log Entry Showing Flash Update Status - Nortel 10BASE-T Using Manual

Write Threshold

To extend the lifetime of the event log's flash memory, a write threshold is set for
each event entered in flash memory. The write threshold is 20 entries for each
event. If any event exceeds the write threshold, an event entry is displayed in the
Event Log screen.
Figure 3-51
Entry Number:
The last event exceeded the write threshold. Further write attempts
by this event are blocked. The write threshold will be cleared when
the switch is reset or when the Event Log is compressed.
Figure 3-51.
The write threshold is reset when either of the following occurs:
•
•

Flash Update

Figure 3-52
Entry Number:
Flash configuration update operation (write or erase) failed.
Configuration information may be lost.
Figure 3-52.
309985-C Rev 00
shows an example of the event log entry for this type of event.
3 sysUpTime: 02:29:44 Reset Count:
Sample Event Log Entry Exceeding the Write Threshold
The BayStack 410-24T switch is reset.
The firmware determines that compression is required for maintenance of the
event log's flash memory.
shows an example of the event log entry for this type of event.
13 sysUpTime: 12:20:38 Reset Count:
Sample Event Log Entry Showing Flash Update Status
Using the Console Interface
2
2
3-123