Nortel 10BASE-T Using Manual page 191

Table 3-16. VLAN Port Configuration Screen Fields
Field
Filter Untagged Frames
Filter Unregistered Frames
Port Name
PVID
Port Priority
Tagging
309985-C Rev 00
Description
Sets this port to filter (discard) all received untagged frames.
Restriction: If this port is a gigabit port or a port that is a protocol-based
VLAN member, you cannot set this field value to No. This restriction also
applies if this port is a trunk member with a gigabit port or a port that is a
protocol-based VLAN member.
Default No
Range No, Yes
Sets this port to filter (discard) all received unregistered packets.
Default No
Range No, Yes
The default port name (with associated stack unit number when
configured) assigned to this port. You can change this field to any name
that is up to 16 characters long.
Default Unit x, Port x
Range Any ASCII string of up to 16 printable characters
Associates this port with a specific VLAN. For example, a port with a
PVID of 3 assigns all untagged frames received on this port to VLAN 3.
Default 1
Range 1 to 4094
Prioritizes the order in which the switch forwards packets received on
specified ports (see "IEEE 802.1p
Default 0
Range 0 to 7
Allows you to assign VLAN Port Membership tagging options to this port,
as follows:
• Untagged Access: Any VLAN that this port is a member of will not be
802.1Q tagged.
• Tagged Trunk: Any VLAN that this port is a member of will be 802.1Q
tagged.
Restriction: If this port is a gigabit port or a port that is a protocol-based
VLAN member, you cannot set this field value to Untagged Access. This
restriction also applies if this port is a trunk member with a gigabit port or
a port that is a protocol-based VLAN member.
Using the Console Interface
(continued)
Prioritizing" on page 1-59).
(continued)
3-49