Nortel 10BASE-T Using Manual page 185

Table 3-13. VLAN Configuration Screen Fields
Field
Delete VLAN
VLAN Name
Management VLAN Allows you to assign any VLAN as the management VLAN. VLAN 1 is the default
VLAN Type
Protocol Id (PID)
309985-C Rev 00
Description
Allows you to delete a specified VLAN, except the assigned management VLAN
(see Management VLAN field). Enter the number of the VLAN you want to delete,
then press [Enter], or use the space bar to toggle through the selection until you
reach the specific VLAN you want to delete, then press [Enter].
The specified VLAN is deleted as soon as you press [Enter]. The software does not
prompt you to reconsider this action. If you delete a VLAN, all configuration
parameters that are associated with that VLAN are deleted also.
You cannot delete VLAN 1. By default, all switch ports are assigned as untagged
members of VLAN 1 with all ports configured as PVID = 1. See
Workgroups" on page 1-38
Default blank field
Range 2 to 4094
Allows you to assign a name field to configured VLANs.
Default VLAN # (VLAN number)
Range Any ASCII string of up to 16 printable characters
management VLAN for the switch. To set this field, the VLAN State field value must
be Active, and the VLAN Type field value must be Port-Based or Protocol-Based
(with the Protocol Id (PID) Field value set to IpEther2).
Default Yes
Range Yes, No
Allows you to select the type of VLAN (port-based or protocol-based) to create. To
set this field, the VLAN State field value must be Inactive.
Default Port-Based
Range Port-Based, Protocol-Based
Allows you to set the protocol type of your protocol-based VLAN (to set this field, the
VLAN State field value must be Inactive). You can choose from any of 15 predefined
supported protocols (see
page 3-45), or you can create your own user-defined protocol-based VLAN (see the
User-defined PID field description for more information).
Default None
Range None, Ip Ether2, Ipx 802.3, Ipx 802.2, Ipx Snap, Ipx Ether2,
AplTk Ether2Snap, Declat Ether2, DecOth Ether2, Sna 802.2,
Sna Ether2, NetBios 802.2, Xns Ether2, Vines Ether2,
Ipv6 Ether2, User-Defined, Rarp Ether2
(continued)
for more information.
"Predefined Protocol Identifier (PID)
Using the Console Interface
"IEEE 802.1Q VLAN
Description" on
(continued)
3-43