Configuring Rmon With The Web-Based Management Interface; Configuring Rmon Fault Threshold Parameters; Nortel Ethernet Routing Switch 5500 Series; Nn47200-505 03.01 Standard - Nortel 5510 Configuration

94 Chapter 3 Configuring Remote Network Monitoring (RMON)
no rmon stats [<1-65535>]
Substitute <1-65535> above with the unique ID of the stats entry.
The no rmon stats command is executed in the Global Configuration
command mode.
Configuring RMON with the Web-based Management Interface
This section discusses the configuration and management of RMON using
the Web-based Management Interface.
Configuring RMON fault threshold parameters
Alarms are used to alert a system administrator when the value of a variable
goes out of range. RMON alarms can be defined on any MIB variable that
resolves to an integer value. String variables (such as system description)
cannot be used as alarm variables.
Creating an RMON fault threshold
To configure an RMON fault threshold, follow this procedure:
Step
1
2
Copyright © 2005 - 2007, Nortel Networks
.
Action
Open the RMON Threshold screen by selecting Fault > RMON
Threshold from the menu. This screen is illustrated below.
RMON Threshold screen
In the fields provided in the RMON Threshold Creation section,
enter the information for the new threshold. The following tables
outlines the fields in this section.

Nortel Ethernet Routing Switch 5500 Series

Configuration - System Monitoring

NN47200-505 03.01 Standard

5.1 27 August 2007