Table of Contents
Advertisement
Check the IP Address Configuration
If your host is allowed to access the VPN Gateway over the network
according to the Access List, check that you have configured the correct IP
addresses on the VPN Gateway. Make sure you ping the host IP address
of the VPN Gateway, and not the Management IP (MIP) of the cluster in
which the VPN Gateway is a member. Type the command /cfg/cur sys
to view IP address information for all VPN Gateways in the cluster.
If the IP address assigned to the VPN Gateway seems to be correct, you
may have a routing problem. Try to run traceroute (a global command
available at any menu prompt) or the tcpdump command (or some other
network analysis tool) to locate the problem. For more information about
the tcpdump command, see the "Network Traffic Dump Commands
" section under Configuration Menu>SSL Configuration Menu in the
Command Reference.
If this does not help you to solve the problem, contact Nortel for technical
support. See
Copyright © 2007-2008 Nortel Networks
.
"How to Get Help" (page
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Check the IP Address Configuration 147
14).
Advertisement
Table of Contents
