Nortel NN46120-104 User Manual page 66

66 Initial Setup
4
Copyright © 2007-2008 Nortel Networks
.
( join setup, continued)
Verify that HSM-SO iKey (purple) is inserted in card 0
(with flashing LED). <insert the HSM-SO iKey specific
for this HSM card> Hit enter when done.
Enter a new HSM-SO password for card 0: <define an
HSM-SO password> Re-enter to confirm:
The HSM-SO iKey has been updated.
Verify that HSM-USER iKey (blue) is inserted in card 0
(with flashing LED). <insert the HSM-USER iKey specific
for this HSM card>
Hit enter when done.
Enter a new HSM-USER password for card 0: <define an
HSM-USER password> Re-enter to confirm:
The HSM-USER iKey has been updated.
Card 0 successfully initialized.
Note: For more information about iKeys, see
iKey Authentication" (page
Initialize HSM card 1 by inserting the second pair of HSM-SO
and HSM-USER iKeys, and by defining passwords.
Remember to take steps to label each pair of HSM-SO and
HSM-USER iKeys and the HSM card to which each set of
iKeys is associated during the initialization. Because each
ASA 310-FIPS device in the cluster will have two HSM cards,
you must also take steps to identify to which ASA 310-FIPS
device each pair of iKeys are associated. Your labeling must
ensure that the connection is obvious between a pair of
HSM-SO/HSM-USER iKeys, the HSM card that was initialized by
using those iKeys, and the ASA 310-FIPS device holding that
particular HSM card.
( join setup, continued)
Verify that HSM-SO iKey (purple) is inserted in card 1
(with flashing LED). <insert the HSM-SO iKey specific
for this HSM card>
Hit enter when done.
Enter a new HSM-SO password for card 1: <define a new
HSM-SO password, or use the same HSM-SO password as for
card 0>
Re-enter to confirm:
The HSM-SO iKey has been updated.
Verify that HSM-USER iKey (blue) is inserted in card 1
(with flashing LED). <insert the HSM-USER iKey specific
for this HSM card>
Hit enter when done.
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
"The Concept of
30).