Nortel NN46120-104 User Manual page 49

5
Settings Created by the VPN Quick Setup Wizard
If you ran the VPN quick setup wizard during the initial setup, a large
number of settings were configured automatically.
Copyright © 2007-2008 Nortel Networks
.
Settings Created by the VPN Quick Setup Wizard 49
•
IPsec group login and secret. Enables IPsec access for the
trusted group, if this group was created with the VPN quick
setup wizard (see
•
Lower/upper IP address in pool range. Lets you specify an
IP address range for use in the unencrypted connection
between the VPN Gateway and the destination host.
•
Network mask for IP pool range. Lets you enter a custom
network mask if the default network mask does not cover the
pool range.
Note: The IPsec quick setup wizard is only displayed if the
VPN quick setup wizard has been run and if the VPN Gateway
has a default IPsec license (not available on the ASA 310
models).
When the Setup utility has finished you can continue with
the configuration.
If you wish to continue configuring the system through the
command line interface (CLI), log in as the admin user with the
password you defined in , and the Main menu is displayed. For
more information about the CLI, see
If you rather configure the system through the Browser-Based
Management Interface (BBI), see the BBI Quick Guide for
instructions.
Initializing system......ok
Setup successful. Relogin to configure.
login:
For instructions on how to deploy a pure VPN solution, continue
with the "VPN Introduction" chapter in the Application Guide for
VPN. For instructions on how to deploy the SSL acceleration
feature, continue with the "Basic Applications" chapter in the
Application Guide for SSL Acceleration.
To join an additional VPN Gateway to the cluster, see
VPN Gateway to an Existing Cluster" (page
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Step 3).
Step
--End--
2.
"Joining a
52).