Table of Contents
Advertisement
148 Troubleshooting the NVG
Cannot Add an NVG to a Cluster
When trying to add a VPN Gateway to a cluster by selecting join in the
Setup menu, you may receive an error message stating that the system
is running an incompatible software version. The incompatible software
version referred to in the error message is the software that is running on
the NVG device you are trying to add to the cluster. This error message is
displayed whenever the NVG you are trying to add has a different software
version from the NVG(s) already in the cluster. In this situation you need
to do one of the following:
•
•
Copyright © 2007-2008 Nortel Networks
.
Adjust the software version on the NVG device you are trying to add
to the cluster, to synchronize it with the software version running on
the NVG(s) already in the cluster. You can verify software versions by
typing the command /boot/software/cur, where the active version
is indicated as permanent. Adjusting the software version on the
NVG device you want to add to the cluster implies either upgrading
to a newer software version, or reverting to an older software
version. In either case you will need to perform the steps described
in
"Reinstalling the Software" (page
software version, log in as the Administrator user and select join from
the Setup menu.
Upgrade the software version running on the NVG(s) in the cluster to
the same version as running on the VPN Gateway you want to add to
the cluster. Perform the steps described in
Release Upgrades" (page
join from the Setup menu.
Nortel VPN Gateway
NN46120-104 02.01 Standard
14 April 2008
70). After having adjusted the
74). Then add the NVG device by selecting
User Guide
"Performing Minor/Major
Advertisement
Table of Contents
