Nortel NN46120-104 User Manual page 64

64 Initial Setup
The following applies when joining a new ASA 310-FIPS to an existing
cluster:
•
•
•
When you log in as the admin user after having started the ASA 310-FIPS
the first time, the Setup menu is displayed.
Step
1
2
Copyright © 2007-2008 Nortel Networks
.
If the ASA 310-FIPS you are about to join is installed on a different
subnet than existing units, this new ASA must be configured as a
slave. Master ASAs cannot exist on different subnets.
If the Access list consists of entries (for example, IP addresses for
control of Telnet and SSH access), also add the cluster's MIP, the
existing ASA's host IP address on Interface 1, and the host IP address
you have in mind for the new ASA to the Access list. This must be
done before joining the new ASA, otherwise the ASAs will not be able
to communicate. Use the /cfg/sys/accesslist command. If the
Access list is empty, this step is not required.
If the ASA you are about to join has a different software version than
existing ASAs, install the preferred software version on the new ASA
before joining it (see
the whole cluster to the same software version as the new ASA (see
"Performing Minor/Major Release Upgrades" (page
/boot/software/cur command to check the currently installed
software version.
Action
Choose join from the Setup menu to add the ASA 310-FIPS
to an existing cluster.
[Setup Menu]
join
new
boot
info
exit
available]
>> Setup# join
Setup will guide you through the initial configuration
of the iSD.
Follow the instructions for joining a VPN Gateway to an
existing cluster.
Read the sections starting with
Existing Cluster" (page
Nortel VPN Gateway
NN46120-104 02.01 Standard
14 April 2008
"Reinstalling the Software" (page
- Join an existing iSD cluster
- Initialize iSD as a new installation
- Boot menu
- Information menu
- Exit [global command, always
"Joining a VPN Gateway to an
52). When the basic setup is completed,
User Guide
70)) or upgrade
74)). Use the