Table of Contents
Advertisement
NTAK03 TDS/DTR card
The NTDK97 MSC card provides the NTAK03 TDS/DTR card functionality.
However, the TDS/DTR card can exist with the MSC card if you want to
access additional TDS/DTR units. You must program these functions in the
software overlays.
Note: At times the system does not operate correctly if you install an
NTAK03 circuit card in a slot connected to telephones. Refer to "Chapter
13 — Installing and connecting the cross-connect terminal" on page 169
to connect an NTAK03 circuit card to the cross-connect terminal.
Procedure 15
NTAK03 card installation
1
Insert the card in its assigned slot.
You can insert the NTAK03 TDS/DTR card into card slots 1 to 3 of the
Main Chassis.
2
Connect an NTAK19EC cable (or an NE-A25-B cable) from the
corresponding connector at the back of the chassis. If you are
using an NE-A25-B cable, terminate this cable at the
cross-connect terminal. Because the NTAK19EC cable is
equipped with connectors, it does have to be terminated at the
cross-connect terminal.
—————————— End of Procedure ——————————
Chapter 12 — Installing the circuit cards
Option 11C Mini
Page 161 of 332
Planning and Installation Guide
Hide quick links:
Advertisement
Table of Contents
