Table of Contents
Advertisement
Page 250 of 332
Activating a customized model without a character display
553-3021-209
Standard 3.00
Chapter 17 — Connecting the telephones
Note: If other keys require secondary extension numbers, you are
prompted until you enter all of the required extension numbers for the
model. These extension numbers cannot be defaulted. The text display
prompting for more extension numbers is "KEY kk EXT?" where "kk"
represents the key number requiring the extension number. Each prompt
for another extension number is accompanied by special dial tone. When
you are programming an extension number, the lamp associated with that
number on the telephone is lit.
4
Hang up the telephone handset.
After approximately 10 seconds, the telephone is configured.
Note: If you replace the handset before you complete the prompt
sequence, the installation automatically fails. This can be useful if you
make an error and want to restart the procedure.
—————————— End of Procedure ——————————
Procedure 38
Activating a customized telephone
1
Plug the telephone set into the jack and wait 20 seconds before
you lift the handset. If you do not receive dial tone, replace the
handset and wait another 10 seconds before going off-hook
again. Repeat this procedure until you receive dial tone.
Note: The system requires the 20 second time interval to determine if
the set is new or if it is being relocated using the Modular Telephone
Relocation feature.
2
Enter the digits associated with the customized model and press
the pound key (#).
Dial tone disappears after you press the first digit. You hear three
beeps followed by continuous dial tone (special dial tone) after you
press the pound key.
April 2000
Hide quick links:
Advertisement
Table of Contents
