Meridian Nortel 1 Option 11C Mini Installation Manual page 227

Chapter 16 — Starting the Option 11C Mini and installing software
20 Enter the keycodes from the Keycode Data Sheet.
Enter new Keycodes:
Key 1:
Key 2:
Key 3:
xxxxxxxx <cr>
yyyyyyyy <cr>
zzzzzzzz <cr>
After you enter the last keycode, the system displays a successful or
unsuccessful message. Follow the instructions given below.
'Keycode validation successful'
***WARNING*** A system restart will occur as part of the software
installation process"
If the successful message appears go to Step 21 on page 227.
'Keycode validation unsuccessful'
If the unsuccessful message appears, repeat this step (Step 20).
After three unsuccessful keycode validation attempts, the following
message appears:
Keycode validation unsuccessful.
Installation aborted...returning to main menu.
21 Complete the software installation.
Are you sure you wish to perform the installation?
y <cr> (yes)
n <cr> (no)
a <cr> (abort, return to main menu)
If the response was YES, this is the end of the Software Installation
program. The system will now start to sysload. See Procedure 27
Step 5 on page 210.
If the response was NO, go to Step 6 on page 218.
—————————— End of Procedure ——————————
Option 11C Mini Planning and Installation Guide
Page 227 of 332